Int 13/AX=057Fh/SI=324Dh

Prev Next Ralf Interrups Categories Contents

------

2M - FORMAT TRACK

AX = 057Fh
SI = 324Dh ("2M")
CH = track number
DH = head number
DL = drive number
ES:BX -> boot sector of future 2M diskette

Return:
CF set on error CF clear if successful AH = status (see #00234)

Program: 2M is a TSR developed by Ciriaco Garcˇa de Celis to support non standard diskettes with 820-902/1476-1558K (5.25 DD/HD) and 984-1066/1804-1886K/3608-3772K (3.5 DD/HD/ED)

InstallCheck:
Must search for a "CiriSOFT:2M:1.3" or "CiriSOFT:2MX:3.0" or similar (recomended ":2M:", ":2MX:", or ":2MB:" substrings) in the CiriSOFT TSR interface

Notes: It is not necessary to call AH=17h or AH=18h first (will be ignored). The diskette format must always begin on cylinder 0 head 0. The boot sector can be obtained from an already-formatted 2M diskette (by calling AH=02h with head number 00h in 2M v1.x and with head number 80h for 2M v2+). Since 2M v2.0, the BOOT sector is emulated using the first physical sector of FAT2; the second-sixth physical sectors of FAT2 in HD or ED diskettes store the SuperBOOT code. To skip the FAT2 emulation (using FAT1) of 2M, in order to read the SuperBOOT code, head number must be 80h-81h instead 0-1 (bit 7 active) in standard read/write functions. This lets diskcopy programs format 2M target diskettes copying SuperBOOT code. If the target diskette is already 2MF formatted (containing boot code) this trick it is not necessary.. When using STV technology (offset 65 of boot sector equal to 1) it is necessary to write the full track before formatting (except track 0 side 0) to complete the format and skip future CRC errors on read; in track 0 side 1 the head used must be 81h instead 1. Diskcopy programs may do a format-write-verify sequential phases to improve performance

See Also: AH=05h"FLOPPY" - AH=18h/CX=5055h - INT 2F"CiriSOFT"

Category: Disk I/O Enhancements - Int 13h - @

------

Prev Next Ralf Interrups Categories Contents